combination trigger / sensitivity modes

[BrianTurner]

My suggestion is to create a mode that has a 'trigger' sensitivity level and then a continuous sensitivity level.

So the issue is that manyt things set off my camera, I set it to 80% which avoids cats, trees etc but it also ends recordings early. So it will pick up a car pulling up on the road out front but it stops when the person gets out of the car and starts walking, So i guess the person walking has fallen below the 80% threashold, if I up it I get a huge amount of false positives from trees blowing in the wind. It would be good to say, OK start recording when something triggers at 80% but then keep recording until activity drops below 40% for example.

I tried just setting the recording to the 2 min max but this killed my batteries too fast and actually some events went on longer than 2 minutes and I then lose out there also.

Combination modes could help get around this.