Arlo|Smart Home Security|Wireless HD Security Cameras

Give us the ability to display the IR Motion Data as a histogram below the video

I have lots of video that gets recorded on one of my camera's and I can't figure out why.  I would like to look at an existing video and figure out what the IR motion sensor is triggering on and at what levels.

 

If I knew the peaks of the videos that end up recording with nothing, then I can set the sensitivity threshold above it.  But right now it's just frustrating trial and error and constant annoyance.

Comments
Tutor

I would ALSO like the histogram data from the few seconds leading UP to the beginning of image recording.

Community Manager
Status changed to: Archived - Not Enough Votes