This topic has been marked solved and closed to new posts due to inactivity. We hope you'll join the conversation by posting to an open topic or starting a new one.
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi All,
Could you please help me to setup a zone in a correct way? So far I tried the following
1/ Settings- My devices - choosing ArtloQPlus cam - Video settings, creaating new zones 1, SAVE
2/ than going to Mode, rules named armed, click on motion is detected item and marking only Zone 1, , making sure everywhere stays unmarked, than clicking on SAVE ....
Doing the above, I thought the zone is correctly defined, however, Arlo cam is ignoring this zones, picking up a motion across the field of view...
Could you please help?
Thanks and regards,
Radim
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Try deleting the zone and recreating it. Edit your mode to use it. Be sure to save
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The Q cameras use a pixel-based motion detection scheme so while the reflection isn't motion per se it sees the reflection as a difference so it triggers. I've trimmed some branches, set sensitivity, adjusted zones, etc. to somewhat help out but I don't really care since I'm not wearing out batteries or filling up space. Yeah, you have more videos to slog through but I'd rather have some false positives than miss something.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
for me i had to go into the edit mode and "motion is detected" menu and click off "everywhere" and select zones. I thought everywhere meant all the zones i created. It actually means everywhere and not the individual zones.