Brightness adjusting
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You move the slider and it won’t change,you have to spend several minutes going back and forth to be able to change brightness
Sometimes it won’t work at all.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The slider isn't really that much of a "slider" - it just provides for 5 distinct settings. Be sure to save when changing. You may have to refresh the view to see the change.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I do refresh and I can see the desired brightness on the display but when I restart I goes back to what it was before,sometimes I get it to work by changing the power management mode
But you shouldn’t go through so much hassle just to adjust brightness
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
To be clear, you are SAVING the new brightness setting, too, right? You must save it.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
How do you save it ?
I just close and press done
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Ah, you made me look, which turns out to be a Good Thing. I was thinking of the old way of setting brightness from live view, not the current method. Although the web interface makes you use live view to set brightness, it saves automatically while the app version has you set it in the camera video settings. As you note, there is no "Save" - it saves for you (or should). You were right all along, I was having a senior moment (or 10).
That said, I have adjusted my brightness on a couple of cameras recently and it remains set. Since that isn't happening for you, I'd suggest rebooting the base and reset the camera by reinserting the battery. If that isn't enough, try removing the camera from Settings, My Devices and resync. You will have to add the camera back into any custom modes if you do thata.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The site,i use the camera to rescue dogs and this pups depend on it
Thank you again
-
Accessories
1 -
Arlo Go
1 -
Arlo Mobile App
67 -
Arlo Smart
13 -
Before You Buy
180 -
Features
64 -
Firmware Release Notes
6 -
IFTTT (If This Then That)
2 -
Installation
126 -
Modes et règles
1 -
Online and Mobile Apps
66 -
Service and Storage
71 -
SmartThings
4 -
Troubleshooting
638