ARLO Wireless Pro Hardware versio H7, Firmware 1.3.314 Will not sync to base. Worked fine befor

[Greatpag]

Camera sat for about 1 month with dead batteries. Replaced batteries, now will not sync with base. Hit the Remove Device option and tried to rejoin but still will not work. Any ideas?

[jguerdat]

Are you sure the batteries are good and properly installed? Do you see a blue flash of the LED when you close the battery door?

[Greatpag]

Batteries are good and installed correctly. The LED illuminated blue when the battery compartment is closed. When I try to sync with base station the LED flashes blue continuously and never stops until I open the battery lid again.

[jguerdat]

Sounds like a bad camera. Swap at the store or open a case with support:

https://www.arlo.com/en-us/support/contact.aspx