- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Just noticed that several of the recordings do not match the programmed record time, which is 30seconds on both my cameras.
The difference is +/- 15s. Anyone else notice this?
Solved! Go to Solution.
Labels:
- Related Labels:
-
Troubleshooting
1 ACCEPTED SOLUTION
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Try power cycling the base. Recording time differences happen but obviously aren't supposed to. Short ones can be due to any dropout of connectivity between the camera and server but certainly not for longer than requested videos.
5 REPLIES 5
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It does happen now and then... don;t know why. ( when set to fixed time )
If you can't stand it tho , you may have to reset the cameras and then the base
--------------------------------------
Morse is faster than texting!
--------------------------------------
Morse is faster than texting!
--------------------------------------
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Try power cycling the base. Recording time differences happen but obviously aren't supposed to. Short ones can be due to any dropout of connectivity between the camera and server but certainly not for longer than requested videos.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This worked. I actually shut everything down from the base to the cable modem and recharged all my cameras to full power. when everything was turned back on - it worked perfectly.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Base station firmware are bricked, I haven't seen any update for the base station.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If you haven't seen an update for the base, why would you say the "base firmware is bricked" ?