Arlo|Smart Home Security|Wireless HD Security Cameras|NETGEAR
Reply
Aspirant

Only one of two cameras shows in MODE section

Why aren't both of my two cameras listed in the MODE section? Only one camera is listed.

Everything shows that my second camera is working properly and I can make adjustments to it under SETTINGS, but it doesn't even show up when I click on the MODE tab. So, I can't ARM it!

Message 1 of 3

Accepted Solutions
Highlighted
Aspirant

Re: Only one of two cameras shows in MODE section

While I was waiting for a reply, and had tried everything else, I finally did what computer repair guys always tell everybody: "Turn it off and then turn it on". So, I clicked on RESTART base, waited for it to finish, synced both cameras again and the problem was solved!

 

Thanks, Guru, for your reply.

Message 3 of 3

All Replies
Guru

Re: Only one of two cameras shows in MODE section

Only the Q cameras show up directly in the Mode tab.  Otherwise, the base(s) will be there.  Select a base and the modes for that base will appear.

Message 2 of 3
Highlighted
Aspirant

Re: Only one of two cameras shows in MODE section

While I was waiting for a reply, and had tried everything else, I finally did what computer repair guys always tell everybody: "Turn it off and then turn it on". So, I clicked on RESTART base, waited for it to finish, synced both cameras again and the problem was solved!

 

Thanks, Guru, for your reply.

Message 3 of 3