Arlo|Smart Home Security|Wireless HD Security Cameras
× Arlo End of Life Policy Notice
To view Arlo’s new End of Life Policy, click here.

Reply
Discussion stats
  • 2 Replies
  • 2574 Views
  • 0 Likes
  • 2 In Conversation
csmonut
Aspirant
Aspirant

Why aren't both of my two cameras listed in the MODE section? Only one camera is listed.

Everything shows that my second camera is working properly and I can make adjustments to it under SETTINGS, but it doesn't even show up when I click on the MODE tab. So, I can't ARM it!

1 ACCEPTED SOLUTION

Accepted Solutions
csmonut
Aspirant
Aspirant

While I was waiting for a reply, and had tried everything else, I finally did what computer repair guys always tell everybody: "Turn it off and then turn it on". So, I clicked on RESTART base, waited for it to finish, synced both cameras again and the problem was solved!

 

Thanks, Guru, for your reply.

View solution in original post

2 REPLIES 2
jguerdat
Guru Guru
Guru

Only the Q cameras show up directly in the Mode tab.  Otherwise, the base(s) will be there.  Select a base and the modes for that base will appear.

csmonut
Aspirant
Aspirant

While I was waiting for a reply, and had tried everything else, I finally did what computer repair guys always tell everybody: "Turn it off and then turn it on". So, I clicked on RESTART base, waited for it to finish, synced both cameras again and the problem was solved!

 

Thanks, Guru, for your reply.