Arlo Pro setting up mode problem

[DeviantCelt]

Ok so I'm trying to work with this thing. I'm having a problem setting up a specific mode. I want to use the regular Armed mode when I'm not home. When I am home I want:

Front Door: On/Motion Detecting

Back Door: On/Motion Detecting

Living Room: Off

Seems simple. And it probably is but here's the problem I'm running into. 

I add a mode called Outdoor Armed. I select Front Door and set it up so that it will be armed. Easy. However, I can't add any more IF statements, only THEN statements. And I can only add extra devices for the THEN statement. For example, IF the Front Door motion detector is activated THEN record Front Door. I can add record Back Door as well... but only IF the Front Door detects motion and not the Back Door.

Basically, I can only have one device trigger an event at one time. I can't have both my Front Door and Back Door motion detect and record and especially not even turn off the Living Room camera. I want all of those to happen at the same time. 

Front Door: On/Motion Detecting

Back Door: On/Motion Detecting

Living Room: Off

Any suggestions?

[DeviantCelt]

Wait, I may have figured it out. Under modes you can add seperate rules. Wasn't quite intuitive to figure out since I had to go back through my mode searching for how to edit things but whatever. I'll see if this works. 

[TomMac]

Once you add and save the first camera...you can always go back and edit to the additional

Remember, any camera NOT in the active mode is OFF