White halo or haze during night vision

[CCcam]

So excited that I installed my new 4 camera set today.  They went up during the daylight and worked great.  With the night vision however, I’m getting a tunnel vision halo effect on three of the four.  Any ideas if this is common with the infra red bouncing off near by objects?  (Eaves, branches, etc.)

[NicoleM]

I’m having the same issue... thought it might be because if the covers I bought to keep rain droplets if the lens but that’s not it. I have 3 cameras doing this- all in vastly different locations pointing different directions with different surroundings.
Moon is very bright tonight... not sure if that is contributing.

[jguerdat]

Post screenshots for suggestions.

[Wboomer]

Having the exact same issue with night vision. It worked great for the first week but now has a white halo around the picture. 

[jguerdat]

Again, post screenshots.

[CCcam]

For me it was a combination of things.  1) The Wasserstein silicon covers with “sunroof” were a huge factor. IMO that sunroof feature is worthless.  I cut the sunroof off the cover and saw an immediate improvement.  2) In the pic I posted you will notice a few branches.  I found that any object like that within a few feet of the camera lens seems to enhance the problem.  I saw the same thing with another camera mounted under the eves on my house.  A section of white trim was causing the halo as well.  I trimmed the branches and repositioned the camera on the house.  Now all seem to be working fine.  

[NicoleM]

Issue was the housing and the little over hang it had to keep rain off the lens. Took it off and problem was resolved!