Unable to rotate image

[Regularpa]

Whar do I need to do to rotate image tryed to reset the entire system and reconnect the camera but no good any ideas what I am doing wrong

[jguerdat]

You invert the image in Settings, My Devices, your camera, Video Settings, Invert Image.

[Regularpa]

Tried that but the invert button it is not highlighted think might have be a problem with my internet 

[TomMac · Accepted solution]

---

Regularpa wrote:

Tried that but the invert button it is not highlighted think might have be a problem with my internet 

---

Don't think its the internet iverting your image....

But the setting may be gliched in the base unit .  If toggling the invert button doesn't work ( do a few times and seave each time ) then , If NG,

reset the camera by opening the battery door and power button reboot the base. Then remove the camera (SETTINGS>camera>REMOVE DEVICE) bring back camera as new.

Last, If still NG, you may have to re-set the base and then resync the cameras as if new

[Nuts4Cats]

In my case the rotate button did finally change to ON but the image is still upside down. That setting just doesn't work. Since these cameras are outside and require a ladder to reach, this process is terribly inconvenient. Might resetting the base by itself work? And does that mean turning it on and off?

[JamesC]

Nuts4Cats,

Consider a base station reboot (using the on-off button) and try again. Are you still seeing the same behavior?

JamesC