Setting up schedule

[Tomdkat29]

Is there anyway to set up a schedule that you don't need to edit everyday? I want to make it so cameras A and B record from 5am to 9pm. And cameras A B and C from 9pm to 5am.

I have the rules set up but I have to edit it for everyday going forward. Is there a way to make his schedule permanent?

[jguerdat]

Certainly.  It's all in the modes you need to configure.  The rules set up the camera, the modes combine them however you want.  So, one mode would turn cameras A and B on while a second mode would turn on A, B and C. Now, go to the schedule and place the A,B,C mode to start at midnight and end at 5 AM.  Position the A,B mode to start at 5:01 AM and end at 9 PM.  Finally, position mode A,B,C to start at 9:01 PM and end at midnight. Repeat for each day.  Save.

[Tomdkat29]

Thanks for the response. I'm confused so I still have to do the setup for each day? I want to set it up once and have it roll forward.

[TomMac]

---

Tomdkat29 wrote:
Thanks for the response. I'm confused so I still have to do the setup for each day? I want to set it up once and have it roll forward.

---

Once you have the proper Modes created... you must set up each day, you can't copy it over to the next day ( unfortunately )...

But a good suggestion for the want list; 

https://community.netgear.com/t5/Idea-Exchange/idb-p/arlo-idea-exchange

[jguerdat]

WHile it's a bit of a PITA to set up the schedule, it's not THAT hard and only needs to be done once.  My schedule prolly took me 5 minutes to implement and hasn't been touched (except for fine tuning) since.