Camera constantly busy on "Position Mode" and "Motion Detection Test"

[dontworkforever]

One of my cameras constantly go into "Position Mode" and "Motion Detection Test" on its own. This has run the battery down to under 10% charged, while my three other cameras are still over 85% charged (all four were installed at the same time). 

Any idea why it is doing this and how I stop this? Thanks in advance!

[TomMac]

About the only easy thing to try is remove and then replace the batteries thereby resetting the camera.

If it continues, contact Netgear for a trouble ticket

PS... Also , go into the program and toggle on the test mode and then back a few times to maybe toggle it fully off.