Ultra 2 camera constant motion after firmware

[arlosucks2]

My camera is constantly recording, even after multiple resets, it happened after a firmware update last week. I can barely keep it charged long enough to mess with it

[StephenB]

---

@arlosucks2 wrote:

My camera is constantly recording, even after multiple resets, 

---

Did you do the full hardware reset?

1. remove the camera from the account
2. open the housing, and press the button inside until the camera LED flashes amber ( ~15 sec)
3. add the camera back to the account

[arlosucks2]

Thanks for replying Stephen, I did that twice, if I plug it in and face it to a corner or in a drawer it just keeps sensing motion almost nonstop

[StephenB]

---

@arlosucks2 wrote:

Thanks for replying Stephen, I did that twice, if I plug it in and face it to a corner or in a drawer it just keeps sensing motion almost nonstop

---

Sounds like something is wrong with the PIR sensor hardware.

[Dangalls]

I had the same problem with all of my 5 cameras since the update, constantly updating the batteries and looking for an alternative system. 

[StephenB]

---

@Dangalls wrote:

I had the same problem with all of my 5 cameras since the update, constantly updating the batteries and looking for an alternative system. 

---

What model are the cameras?