This topic has been marked solved and closed to new posts due to inactivity. We hope you'll join the conversation by posting to an open topic or starting a new one.
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I just put a Ultra2 camera to monitor cross walk traffic. Its connected to an outdoor electrical plug so we do not need to change batteries.
When we first started using it, the video seemed fine, but now the right side of the video is PINK. You can still see whats being viewed but the pink color is annoying.
Would that be something on the camera lens?
Solved! Go to Solution.
- Related Labels:
-
Troubleshooting
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
@rdilauro wrote:
Where would I set the nigh vision IR filter?
You can't. If nightvision is enabled for the camera, the IR filter is automatically engaged if the camera senses it is too dark for low-light color. And automatically disengaged when the camera senses it has enough light.
You could try gently shaking the camera to see if that dislodges the filter. Some folks have found that moving a strong magnet around the front of the camera housing also does the job.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
@rdilauro wrote:
Would that be something on the camera lens?
Likely the nightvison IR filter isn't completely disengaged.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I looked under Video Settings
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
@rdilauro wrote:
Where would I set the nigh vision IR filter?
You can't. If nightvision is enabled for the camera, the IR filter is automatically engaged if the camera senses it is too dark for low-light color. And automatically disengaged when the camera senses it has enough light.
You could try gently shaking the camera to see if that dislodges the filter. Some folks have found that moving a strong magnet around the front of the camera housing also does the job.
-
Arlo Mobile App
202 -
Arlo Smart
141 -
Arlo Ultra 2
1 -
Before You Buy
249 -
Features
304 -
Installation
269 -
Prima di acquistare
1 -
Troubleshooting
910