Arlo|Smart Home Security|Wireless HD Security Cameras

ABB1000 Bridge Motion Dectectors

Reply
Discussion stats
  • 3 Replies
  • 1031 Views
  • 0 Likes
  • 2 In Conversation
nmjones
Aspirant
Aspirant

I have two motion detectors for my ABB1000 bridge. When they activate, I get two seperate times displayed. The first time displayed shows the correct time. The second time displayed shows incorrect time (one hour ahead). I have included an attachment to help with what I'm trying to describe. I am in Arizona and have Arizona time zone selected. I also have 8 cameras (5 Arlo Pro 2 cameras and 3 Ultra 2 cameras. None or these have that issue. Any suggestions.

Screenshot_20240410_100853_One UI Home.jpg

1 ACCEPTED SOLUTION

Accepted Solutions
jguerdat
Guru Guru
Guru

Have you tried removing and readding the device to see if that helps?

View solution in original post

3 REPLIES 3
jguerdat
Guru Guru
Guru

Have you tried removing and readding the device to see if that helps?

nmjones
Aspirant
Aspirant

Not yet. About two months ago I installed my new Ultra Pro 2 cameras. To get the motion detectors to work again, I had issues and had to do factory resets. Back at that time, I ended up doing about 3 factory resets. I figured I would do it again, but first, I wanted to see if anyone knew for sure what was going on. I'm not sure when this issue started. Just noticed it a few days ago.

nmjones
Aspirant
Aspirant

OK. Factory reset resolved issue. Guess I was being lazy. Didn't want to get on a ladder, remove my motion detectors and rescan bar codes.

Discussion stats
  • 3 Replies
  • 1032 Views
  • 0 Likes
  • 2 In Conversation