Arlo|Smart Home Security|Wireless HD Security Cameras
× Arlo End of Life Policy Notice
To view Arlo’s new End of Life Policy, click here.

Reply
Discussion stats
  • 2 Replies
  • 3202 Views
  • 0 Likes
  • 3 In Conversation
Natethegriff
Follower
Follower
Our power went out due to a storm a few weeks ago and all of our arlo system shut down but then rebooted except for one of our arlo q's. The Arlo Q started to blink amber, blue and purple. I tried resetting it and removing it from our devices. Whenever I push the reset button on the camera, it reboots (solid amber light) and then starts blinking purple, blue and amber. The camera is now is at a point to where I can't connect or reset it. It's pretty much a $150 sitting potato. Any suggestions on how to fix it? Thanks!
2 REPLIES 2
jguerdat
Guru Guru
Guru

If the reset didn't help, try swapping the power supply  If no good, open a case with support for a possible RMA.

bcleaver
Star
Star

When I enquired about this in another thread it was said to be a combination of "firmware update" (amber blue) and "too far away from wifi". Whatever the cause, I found that it only delayed the boot - if I let the camera sit flashing away it would eventually come back up.