- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am getting a lot of nusance motion alerts outside of the ares that I defined for detection. This is a brand new system to me so I am still learning, but it looses much value if I cannot correct this and will have to return for refund.
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Paul_S_B,
After setting motion detection zones, you must then select those zones within your rules.
To do this, log in to your Arlo account and navigate to Mode > select your Arlo Q > select the mode you wish to edit > click edit on the desired rule > edit "Motion Detected" and select which zones you would like motion detection to be active in. Be sure to save your changes when finished.
JamesC
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Paul_S_B,
After setting motion detection zones, you must then select those zones within your rules.
To do this, log in to your Arlo account and navigate to Mode > select your Arlo Q > select the mode you wish to edit > click edit on the desired rule > edit "Motion Detected" and select which zones you would like motion detection to be active in. Be sure to save your changes when finished.
JamesC
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you James as your instructions appear to have resolved my issue.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Magosanx,
Consider rebooting the camera and try again. Do you still see the same behavior?
JamesC