Pixelated and vertical lines video on all cameras starting 3/4/2021. WiFi is working fine.

[msweeden]

I've had had an Arlo base station and 2 Arlo Pro cameras for nearly 4 years, and they have always worked fairly well. Staring 2 days ago (3/4/21) I am not getting motion recording when I should, and both cameras are routinely recording shortened video with pixelation and vertical lines. I don't know if this is due to a firmware update or service update with Netgear. My WiFi network is working fine. Since it's on both cameras, I think the cameras themselves can be ruled out (unless this is caused by a firmware update). Any light on resolving this issue would be appreciated. I have already tried resetting the cameras and the base station to no avail.

[jguerdat]

You can always check when updates are done by looking in the Firmware Release Notes section here. The latest release was the middle of February so it's likely not a firmware update that caused this. Try moving the base away from the router as much as possible - I had to do this a while ago after having it almost touching the router for years.

[dianaWVUPhan]

Came here searching for possible solutions for why 3 of my 5 cameras that had been working fine for several years stopped detecting motion about a week ago.  Initially I tried removing and re-adding the cameras which did not solve the issue.  I then removed the batteries for a bit and this did not solve the issue.  

I then tried  jguerdat's  advice to remove the base station away from my router and BINGO.  That worked!!