Arlo|Smart Home Security|Wireless HD Security Cameras|NETGEAR
Reply
Highlighted
Aspirant

My Arlo Pro Wire-Free camera won’t sync with the base station; what do I do?

HI Fellow Arlo users,

Just purchased a brand new Arlo Pro combo with base station and 3 cameras. With the base station connected to the net  and powered up (green lights OK). I then tried to sync one of the 3 cameras with the same result. Unable to sync any cameras.

The sync light flashes on the base station when pressed for the 2 secs, then pressing one of the  cameras sync buttion for 2 secs, the blue light flashes slowly. After a period of approximatley 30 seconds the amber light flashes fast on the camera, and the green light on the base station extinguishes itself. Help please......not a happy customer presently

Model: VMC4030| Arlo Pro Wire-Free Camera
Message 1 of 19

Accepted Solutions
Aspirant

Re: My Arlo Pro Wire-Free camera won’t sync with the base station; what do I do?

Hello All,

Ive had success this morning, after powering the system down for an entire day it now works perfectly.?

Cameras have update there firmware settings as did the base station.

Not quite sure it finally worked, but thats electronics for you.

Thansk to too all your inputs for my dilemma 

 

regards

ian

Message 11 of 19

All Replies
Master

Re: My Arlo Pro Wire-Free camera won’t sync with the base station; what do I do?

For good measure, factory reset the base using a paper clip, hold in until all lights turn amber.

Then begin the process from scratch.

You only need a momentary press of the sync button on the base.

Message 2 of 19
Aspirant

Re: My Arlo Pro Wire-Free camera won’t sync with the base station; what do I do?

Is the camera charged?
Message 3 of 19
Aspirant

Re: My Arlo Pro Wire-Free camera won’t sync with the base station; what do I do?

Hi Prodigy,

Ive completed the tasks,unfortunatley they havent worked. Seems to effect all cameras with the same result.

I have now made an decision to strat charging one camera and test after the battery is fully charged. Netgear report

there batteries are fully charged although perhaps not enough to transmit across 2.4 adn 5ghz. Time will tell.

Otherwise its back to the retailer for a refund/replacement.

Message 4 of 19
Aspirant

Re: My Arlo Pro Wire-Free camera won’t sync with the base station; what do I do?

It appeared charged without any indication of battery failure. I will therefore endeavour to charge 1 camera , so i can eliminate this from my fault.

Message 5 of 19
Aspirant

Re: My Arlo Pro Wire-Free camera won’t sync with the base station; what do I do?

I read the fully charged comment from the factory statement too. Finally plugged it in to charge and it finally synced.
Message 6 of 19
Guru

Re: My Arlo Pro Wire-Free camera won’t sync with the base station; what do I do?

You can also try syncing while plugged in.  The camera will run fine on just the power supply.

Message 7 of 19
Aspirant

Re: My Arlo Pro Wire-Free camera won’t sync with the base station; what do I do?

You can also try syncing while plugged in.  The camera will run fine on just the power supply.

Ive tried various tasks,Reboot,power cycle moving base away from router, camera fully charged, also camera fully chraged and plugged into power supply. Still no sync.

I've tried a base station factory reset , now we have solid green lights on the power, internet and a Solid AMBER light on the camera led.

Tried syncing again and no sync available, I need my money back grrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrr

Message 8 of 19
Aspirant

Re: My Arlo Pro Wire-Free camera won’t sync with the base station; what do I do?

Base station will not sync even with camera plugged in grrrrrr

Message 9 of 19
Guru

Re: My Arlo Pro Wire-Free camera won’t sync with the base station; what do I do?

Sounds like a faulty base. Either swap the system at the store or open a case with support using the Contact Support link at the bottom here.

Message 10 of 19
Aspirant

Re: My Arlo Pro Wire-Free camera won’t sync with the base station; what do I do?

Hello All,

Ive had success this morning, after powering the system down for an entire day it now works perfectly.?

Cameras have update there firmware settings as did the base station.

Not quite sure it finally worked, but thats electronics for you.

Thansk to too all your inputs for my dilemma 

 

regards

ian

Message 11 of 19
Master

Re: My Arlo Pro Wire-Free camera won’t sync with the base station; what do I do?

Good job Ian.

Well done for persevering and thanks for the feedback.

Message 12 of 19
Aspirant

Re: My Arlo Pro Wire-Free camera won’t sync with the base station; what do I do?

when I plug it in to the charger nothing happens  no blue light

Message 13 of 19
Aspirant

Re: My Arlo Pro Wire-Free camera won’t sync with the base station; what do I do?

how do you know it is charged ?

Message 14 of 19
Aspirant

Re: My Arlo Pro Wire-Free camera won’t sync with the base station; what do I do?

I tried this and it still did not sync

Message 15 of 19
Aspirant

Re: My Arlo Pro Wire-Free camera won’t sync with the base station; what do I do?

same with me   grrrrrrrrr  I will be really upset if they try to give me a 15% restocking fee!

Message 16 of 19
Community Manager

Re: My Arlo Pro Wire-Free camera won’t sync with the base station; what do I do?

bonrab21,

 

Please contact the Arlo Support Team to further investigate this issue. You will find several options for contacting support in the provided link.

 

JamesC

Message 17 of 19
Aspirant

Arlo pro

My cameras wont sync with base

Model: VMC3030 | Arlo Wire-Free Camera
Message 18 of 19
brh Master
Master

Re: Arlo pro

@Gmang

Here is a link to an article on how to troubleshoot your problem.

 

https://kb.arlo.com/000039094/My-camera-will-not-sync-with-the-base-station-how-can-I-troubleshoot-i...

 

Brian

Message 19 of 19