Arlo Pro

[Arizzo]

How can I stop so many alerts from coming in every minute? 

I have reduced the target area for motion to a minimum (almost making the cameras completely useless because I cannot see the entire area as I was hoping), but I still get alerts every minute for no apparent reason. 

Is there a way to change the sensitivity of the cameras so that it is not alerting after every speck of dust passes the lense?

[jguerdat · Accepted solution]

Pan and zoom has no effect on motion detection since the PIR motion detector sees the whole scene.  You're just cropping the video.

Post a screenshot with pan and zoom turned off (zoomed back out completely). It may be your positioning or it could be a bad camera.  Putting the camera in a location where there is no motion (inside a room, facing a wall) would be useful to tell if the camera is flaky.

[TomMac]

Is there a way to change the sensitivity of the cameras so that it is not alerting after every speck of dust passes the lense?

Yes, there is a sense level adjustment in the MODE, under record

[Arizzo]

Thank you, TomMac!  I didn't know about the feature.

[Arizzo]

OK, thank you. I will try this as well.