2nd Pro 3 camera added via "Add Device" not recording

[Johnfj40]

I cannot get the Add Device feature to work when the added device is a camera. I have multiple Pro 3 cameras installed and when motion is detected on Camera A, for example, I want Camera A and Camera B to record. Right now Camera B will not record when motion is detected by Camera A even though it's included in the "Then do the following" section of the rule. Thanks.

[StephenB]

---

@Johnfj40 wrote:

Right now Camera B will not record when motion is detected by Camera A even though it's included in the "Then do the following" section of the rule. Thanks.

---

Do you have activity zones set up for Camera B?  If so, try deleting them,. and then test again.

Another poster ran into this issue a little while ago, and figured out that the activty zones in the triggered camera was surpressing the recording.

[dcfox1]

I haven't used cross triggering in a while but when I did if the motion in camera B was outside the zone it was disregarded. I assume it has to do the position of the second camera. What @StephenB said is a good way to test it.