This topic has been closed to new posts due to inactivity. We hope you'll join the conversation by posting to an open topic or starting a new one.
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I cannot get the Add Device feature to work when the added device is a camera. I have multiple Pro 3 cameras installed and when motion is detected on Camera A, for example, I want Camera A and Camera B to record. Right now Camera B will not record when motion is detected by Camera A even though it's included in the "Then do the following" section of the rule. Thanks.
- Related Labels:
-
Features
-
Troubleshooting
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
@Johnfj40 wrote:
Right now Camera B will not record when motion is detected by Camera A even though it's included in the "Then do the following" section of the rule. Thanks.
Do you have activity zones set up for Camera B? If so, try deleting them,. and then test again.
Another poster ran into this issue a little while ago, and figured out that the activty zones in the triggered camera was surpressing the recording.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I haven't used cross triggering in a while but when I did if the motion in camera B was outside the zone it was disregarded. I assume it has to do the position of the second camera. What @StephenB said is a good way to test it.
-
Arlo Mobile App
397 -
Arlo Pro 3
7 -
Arlo Secure
2 -
Arlo Smart
308 -
Before You Buy
290 -
Features
388 -
Firmware Release Notes
4 -
Installation
344 -
Online and Mobile Apps
15 -
Service and Storage
17 -
Troubleshooting
1,786