- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Motion detection on one of my Arlo Pro 2 camera stopped working. I have tried running motion detection tests on the camera. The senstivity is set to 100%, but I still do not see a blinking light. I have two other cameras that came in the set and they work fine. Any suggestions? Thanks.
- Related Labels:
-
Troubleshooting
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can also try removing the camera from Settings, My Devices and resync to see if that helps.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
@swolf76 wrote:
Motion detection on one of my Arlo Pro 2 camera stopped working. I have tried running motion detection tests on the camera. The senstivity is set to 100%, but I still do not see a blinking light. I have two other cameras that came in the set and they work fine. Any suggestions? Thanks.
I have had the same problem since yesterday. 2 cameras working the third the motion detection does not work. I have tried everything eg re syncing, delete device, re boot, charging the battery, turning up and down sensitivity and still no luck. Only had the cameras 3 months. Any ideas?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Who did you call Arlo or from where you bought it from? Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dnmneil,
Are you using a custom mode or the default "Armed" mode? Is the running man icon on the camera widget for the affected camera showing as gray or black?
JamesC
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have tried the default and a custom one with same result....no detection. The running man is shown as black
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you all for you advice. Here is what I did to fix the problem:
- I removed the device from the list of cameras.
- I removed the battery from the camera and then reinserted it.
- Finally, I resynced the camera with the base station, and viola, it is now working again!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I will try that. Thanks
-
Arlo Mobile App
563 -
Arlo Pro 2
11 -
Arlo Smart
164 -
Before You Buy
969 -
Features
405 -
Firmware Release Notes
57 -
Google Assistant
1 -
IFTTT (If This Then That)
24 -
Installation
1,115 -
Online and Mobile Apps
865 -
Service and Storage
317 -
SmartThings
37 -
Troubleshooting
6,107