Weak detection after cameras got deleted from base station and re added.

[toekneedice]

had these cameras for a while and always had silicone covers on them. However one day some how they got deleted off the base station and once I added all cameras again. They were not the same. They didn’t pick up detection like they used too.

i went from having 400 notifications to 20 in 24hrs 

[StephenB]

---

@toekneedice wrote:

is there any way to reset the camera itself?

---

Not Pro 2 cameras.

You can try removing the battery for a minute or so, and then reinsert it.

[StephenB]

---

@toekneedice wrote:

had these cameras for a while and always had silicone covers on them. However one day some how they got deleted off the base station and once I added all cameras again. They were not the same. They didn’t pick up detection like they used too.

i went from having 400 notifications to 20 in 24hrs 

---

Check the motion sensitivity and see if that changed when you re-added the cameras.

[toekneedice]

Thanks for the reply. 
I checked and they were all the way 100. 
is there any way to reset the camera itself?

[StephenB]

---

@toekneedice wrote:

is there any way to reset the camera itself?

---

Not Pro 2 cameras.

You can try removing the battery for a minute or so, and then reinsert it.