Can't sync the Pro 2 cam. My cam keeps blinking blue and amber for week.

[PHAM1970]

I discovered one of my arlo pro 2 cameras went offline. I thought it run out of battery. I charged it overnight but the cam then still goes offline. I then removed and tried to add it back again. However, after removing it, I can't sync it again. The led on a cam is alternately blinking blue and amber for a week. After searching through discussions in this community, I figured out that my cam may have been stuck in nowhere during the firmware update. 

I appreciate anyone help get me out of this problem.

Thank you

[jguerdat]

Pull the battery for a couple of minutes and then reinsert. Does the LED still alternate between blue and amber? If so, use Settings, Support to see if you can access additional help.

[PHAM1970]

Hi Jguerdat,

Have done what you said. However, the LED still alternate blue and amber. I also tried using Settings, Support but I can't get a live support as I am not subscribing. It is so sad. my cam now is a brick

Is there any other way to bring it back?

I appreciate any help

Thx

[jguerdat]

I've seen suggestions that holding the camera's sync button for >15 seconds may help but can't verify that myself. If that doesn't work, I'd say you have a faulty camera that needs to be replaced.

[Bsmith741]

Pretty sure arlo did it to make us upgrade

[dcfox1]

---

@Bsmith741 wrote:
Pretty sure arlo did it to make us upgrade

---

Things fail. It's not a conspiracy.