This topic has been closed to new posts due to inactivity. We hope you'll join the conversation by posting to an open topic or starting a new one.
Arlo Chime unable to connect
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I purchased an Arlo doorbell and was unable to get my traditional chime to work with it, so I purchased the Arlo chime. I have attempted to add this chime multiple times without success. Each time, I wait several minutes while the chime slowly blinks white. Then, the light turns amber and there will be several seconds where it flashes quickly before becoming a solid amber light. I have tried resetting it several times to no avail. My cameras and lights are working fine. The chime is located ~six feet from wi-fi router. I cannot seem to find any troubleshooting for this or if there is a way to do a hard reset on this device only. Any advice would be appreciated, as I am ready to return this and the doorbell.
- Related Labels:
-
Troubleshooting
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The chime connects to the base, not your router. You can try moving the chime close to the base and see if that allows it to be connected. Then move it back where you want it.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Could be. Swap at the store or open a case with support here.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have the exact same issue. Did you ever find any solution?
On power-up, slow blinking white, then blinking amber, then solid amber. Solid amber isn't even explained in the FAQ / Manual.
Manual pairing made it show up in the app, but when unplug / replug the Chime it's again the same thing and it disconnected from the app and base station.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Have you tried to remove the camera from Settings > My Deices > reset the chime by holding down the Sync button for 10 seconds then re-adding it?
-
Arlo Mobile App
24 -
Arlo Smart
7 -
Before You Buy
106 -
Features
29 -
Firmware Release Notes
8 -
Installation
109 -
Online and Mobile Apps
59 -
Service and Storage
11 -
Troubleshooting
393