Is there a way to have "motion detection" auto disengage rather than using a timer to

[Karaoke_Carlos]

I am recordng a moderate traffic area.  My concern is that sometimes there may be activity I want to record that lasts 20 seconds.  Other times, it may last 120 seconds.  Is there a way to record "only as long as there was activity" rather than recording on a set time frame each time the motion sensors are activated?

[TomMac]

No... it will detect motion and record for the time specifed.

But if motion occurs again it can keep going/record again for the time

[CaptainDork]

I can walk out into the yard and the cam will pick me up for ten (10) seconds and then appears to give up on me. 🙂

I'm wondering if you know the "recovery" time from the end of one event to the beginning of another?

I don't mind if a recording is in pieces.

I think I am missing some contuinuity, though.

Thank you.

[jguerdat]

It depends on the motion detection.  As you move in and out of range, motion may not be detected.  It may help to increase sensitivity but it'll be a trial and error process.