Arlo|Smart Home Security|Wireless HD Security Cameras

Reply
Discussion stats
  • 2 Replies
  • 2775 Views
  • 0 Likes
  • 3 In Conversation
nicholshornlake
Luminary
Luminary

Just finished installing 3 camera arlo. 2 are working good, but one always says request timed out. No picture at all. I have re synced and re synced; even rebooted the base station, still no luck. Anyone have any ideas? Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
JamesC
Community Manager
Community Manager

nicholshornlake,

 

Welcome to the community! It is possible interference between the base station and the camera is causing it to time out. Another possibility is weak WiFi signal due to range which causes the camera to struggle to maintain a conntection to the base station. Please consider the following troubleshooting steps:

 

1. Swap the location of the affected camera with a working camera to isolate if interference is the cause.

2. Bring the affected camera close to the base station and attempt to stream.

3. Relocate the base station.

 

Let us know if this helps!

JamesC

 

 

View solution in original post

2 REPLIES 2
jguerdat
Guru Guru
Guru

I'd open a trouble ticket - might be a bad camera.

JamesC
Community Manager
Community Manager

nicholshornlake,

 

Welcome to the community! It is possible interference between the base station and the camera is causing it to time out. Another possibility is weak WiFi signal due to range which causes the camera to struggle to maintain a conntection to the base station. Please consider the following troubleshooting steps:

 

1. Swap the location of the affected camera with a working camera to isolate if interference is the cause.

2. Bring the affected camera close to the base station and attempt to stream.

3. Relocate the base station.

 

Let us know if this helps!

JamesC