Confused by scheduling mode

[anuva]

I'm trying to set up the cameras to "arm" (record motion and send notification) between 10 PM and 6 AM. I go into Mode -> Schedule -> click the current "All Motion On" block of hours and change Start Time from 6 AM to 10 PM and Stop Time from 9 PM to 6 AM, but I get a purple X icon on both changes and the Save button is greyed out. Thus I can not change the scheduled time. Am I missing something or is this not possible?

[Streak2 · Accepted solution]

You need to do it in two steps. Schedule does not allow you to go across days in one step.

So do 10pm to 11:59 and then 12:00 to 6am.

[anuva]

I was afraid that was the case. I'll give that a try. Thanks

[anuva]

Also, what's the difference between "Armed" and "All Motion On" in the Schedule screen?

[anuva]

Nevermind, I figured it out - Armed use to be called All Motion On with the old software/firmware and Netgear didn't delete it automatically during upgrade.

[TomMac]

---

anuva wrote:

Nevermind, I figured it out - Armed use to be called All Motion On with the old software/firmware and Netgear didn't delete it automatically during upgrade.

---

If you have ALL MOTION ON along with ARMED, it may be better to remove/delete the "all motion on" mode as some have said it can cause issues at times.

[anuva]

Yup, I did just that. Thanks!