Arlo camera will sync properly but does not activate so I can not see it. I changed the batterie

[cmbutlerllc]

The camera will sync just fine but it does not show up as being active on my account? It does not show up at all. 

the blue lights blink but then go dead after it has synced. Is that normal? I have put in new batteriers even though the system is only three months old. the other three cameras are working just fine. 

[steve_t · Accepted solution]

When you hit the sync button, the blue LED will blink slowly. When it syncs with the base, the blue LED should start blinking quickly before turning off

[cmbutlerllc]

For some reason, this morning, the non active camera is showing up on my account and is active now. It was programmed for motion detection which did active during the night. We are good for now. Thank you for your help!