Arlo|Smart Home Security|Wireless HD Security Cameras
× Arlo End of Life Policy Notice
To view Arlo’s new End of Life Policy, click here.

Bridge ABB1000 cannot be discovered

Reply
Discussion stats
  • 2 Replies
  • 3089 Views
  • 0 Likes
  • 3 In Conversation
stevendalesmith
Follower
Follower

We have a Netgear Model ABB1000 bridge trying to sync to our Arlo camera system. We have a Netgear CM700 modem and are hooked up to a Eero router. The Geek Squad tried to help and found that we have a legacy band 2.4ghz bridge trying to communicate to 5.0ghz. We have spent over $600 on Arlo outside lights and $125 to the Geek Squad who says we need an upgraded bridge that Netgear made specifically for the Arlo that currently doesn't sync because it's old technology. Is that at all possible to get an upgraded bridge that will work with this network setup? Currently the lights are worthless. Thanks for your help. Steve

1 ACCEPTED SOLUTION

Accepted Solutions
jguerdat
Guru Guru
Guru

OP, do you have both 2.4 and 5GHz bands enabled on your router? Are both set to use the same SSID or do they have distinct SSIDs?

View solution in original post

2 REPLIES 2
TomMac
Guru Guru
Guru

The Light Bridge ,TMK, only operates at 2.4 ghz and there is no 5 ghz model at this time

--------------------------------------
Morse is faster than texting!
--------------------------------------
jguerdat
Guru Guru
Guru

OP, do you have both 2.4 and 5GHz bands enabled on your router? Are both set to use the same SSID or do they have distinct SSIDs?

Discussion stats
  • 2 Replies
  • 3090 Views
  • 0 Likes
  • 3 In Conversation