Connection strength is lower with firmware 1.14.1.1_2913_7

[jlowe73]

I've just been "upgraded" to 1.14.1.1_2913_78b189a, and now all my cameras have 2 bars connection, despite me knowing full well some cameras should have 1 bar, and others should have 3.

On top of this, one of the cameras (the one that used to say 1 bar, but now has 2 bars) is not picking up all movement.  I get the occasional recording, but not all the recordings I expect.  eg: a CAR leaving the drive is not recorded, but a person walking through is.

I have rebooted, and checked all the settings for the modes (this is hapenning on 3 different modes, same camera)

Is this a known issue in the latest firmware that all cameras have the same signal strength shown?  what can I do to troubleshoot?