Fog setting off motion on pro 3 only

[Iamspartacus8]

I have a mix of arlo pro, pro2 , ultra and just added a pro 3 .  The pro 3 motion sensor constantly goes off due to fog.  I have adjusted angle, cut down motion zones, reduced sensitivity , nothing works?

this am after a particularly foggy night I had 91 recordings of the mist. (Snow is coming soon) 

by the way, it is only the pro3 that has this issue.  Thanks 

[jguerdat]

None of my Pro 3s do this. Start by rebooting the base and remove the camera from Settings, My Devices. Resync. ANy better? If not, try swapping cameras around.

[JamesC]

Iamspartacus8,

Are you sure it's the fog and not something else at that location causing the trigger? You might try swapping the location of your Pro 3 and one of your other cameras (temporarily) to see if the issue follows the camera or the location.

JamesC

[damlkm]

Mine does the same thing in fog.  A recording every minute or two - it really is annoying.  I've messed with the sensitivity settings, and that doesn't seem to do anything.

[jguerdat]

Are you changing the sensitivity setting in your modes and rules?

[damlkm]

Yes.  I change the sensitivity in the modes and rules from 1 - 100 without any noticeable effect.