base station and camera pro 2 won't sync

[markgrrrr]

My pro 2 camera stopped recording when there was motion. I did the motion test and it blinked amber, like it is supposed to. I looked through all the settings I could find and didn't find a setting that turned the activity monitor off or on.

So I uninstalled the camera and tried reinstalling it. It did the slow blue blink, then the fast blink thing like it was connected. Never showed up in the app. I uninstalled the camera and reinstalled it. No luck.

I uninstalled the base station. Reinstalled it. Tried to sync the camera. No good.

I uninstalled the base station. Reset it. Reinstalled the base station. Tried reinstalling the camera. Same thing. Slow blue blink. Fast blue blink but it never showed up in the devices. 

 I did all of the above actions several times. What else can I try to get this to work? 

[DannyBearAgain]

Try using the manual sync method, momentarily pressing the top button on the base then same on the camera.

Do the same again next time the camera acts up again.

[BrookeN]

@markgrrrr are you still seeing this same behavior?

[markgrrrr · Accepted solution]

After I sent that, I saw another post about a person using the wrong Arlo camera. I found the correct Arlo camera and it worked. I couldn’t figure out how to delete my post. 

Thank you for the reply