Arlo|Smart Home Security|Wireless HD Security Cameras

Pro2 - Not recording incoming traffic properly

Reply
Discussion stats
  • 3 Replies
  • 813 Views
  • 0 Likes
  • 2 In Conversation
fancy1
Aspirant
Aspirant

My Arlo Pro 2 was working great until I had to charge it.  Then all of a sudden it seems to record outgoing fine, but only records incoming within 10-20 feet.  It will not pick up incoming any longer from the distances it previously did any longer.  Anyone else experience this problem?

3 REPLIES 3
TomMac
Guru Guru
Guru

did you change the angle of camera ... ?  aiming down a bit would lower disitance.

PIR maxs out to about 25ft for people

 

Or

 pull battery then replace to reset camera...test again.

--------------------------------------
Morse is faster than texting!
--------------------------------------
fancy1
Aspirant
Aspirant

hello @TomMac I Changed the angle of the camera to make sure it was covering the area correctly.

Yes, pulled battery out, and re-synced.

Prior to charging, it was previously detecting the motion of incoming traffic from the same distance as outgoing traffic being recorded leaving's distance going out.  Now it will not detect incoming until it is almost right at the camera.

TomMac
Guru Guru
Guru

Next , if you haven't yet, check the sense level and confirm it is not at the default of 80...

most of mine sit between 90 and 93%

--------------------------------------
Morse is faster than texting!
--------------------------------------
Discussion stats
  • 3 Replies
  • 814 Views
  • 0 Likes
  • 2 In Conversation