- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
When using the keypad sensor hub to change mode to Arm home, the system immediately changes state unlike when changing mode to Arm Away where there is a delay allowing person to leave before changing state.
Is there a way to insert this delay for changing mode to Arm Home also. This is useful when leaving the premises and there are still other people in the house.
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
ajfjavi,
You can add a delay for Arming or Disarming your system within your Arlo location settings. Take a look here for instructions on how this is done: https://kb.arlo.com/000062780/How-do-I-configure-an-entry-or-exit-delay-for-my-Arlo-Home-Security-Sy...
JamesC
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can't change the delay (or lack thereof) but you could use the Automations to set up geofencing. Of course, that means the other folks would need the Arlo app on their phones with GF set up.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
ajfjavi,
You can add a delay for Arming or Disarming your system within your Arlo location settings. Take a look here for instructions on how this is done: https://kb.arlo.com/000062780/How-do-I-configure-an-entry-or-exit-delay-for-my-Arlo-Home-Security-Sy...
JamesC