- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have 8 Arlo Go cameras at the same 5 acre location everyother day one will go offline and it will be offline for an entire day sometimes two to three days then for no reason come back on.
Here is the rub just before a camera will go offline for example camera one is working fine but then I will get an email stating Camera One has been reconected and was offline for 760 seconds I then immediatly check it and see that it has been taken offline.
It seems Arlo states a camera has been reconected but takes the camera offline instead.....Call me kRaZy but I would bet if Arlo stopped sending those emails cameras would stay online.
I have no idea other than that why my cameras keep going offline its not a weak signal otherwise the others would all drop off line as well. Help!
- Related Labels:
-
Troubleshooting
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
1AllSeeingEye,
Have you tried to reboot the camera from the App & monitor again?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have tried everything you cannot reboot remotely you can only remove a device completely remotely.
I have tried new chips removing batteries reloading re-adding the camera.
Nothing works the camera will come back on I will drive 100 miles back home next day offline again then 4-5 days later for no reason comes back on then goes back off half hour later for another 3-4 days and so on..
Remember I have 8 cameras back to back on different areas of my property all connected to power so it’s not signal etc
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Have you tried swapping cameras around to verify that it's not position-related?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I wonder if that could caause a problem. I don't know that anyone has used that setup. It might still be worthwhile swapping cameras around or at least separating the two by a few feet for testing.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Only one out of the two constantly goes off on that spot
-
Accessories
1 -
Arlo Go
1 -
Arlo Mobile App
77 -
Arlo Smart
14 -
Before You Buy
182 -
Features
67 -
Firmware Release Notes
6 -
IFTTT (If This Then That)
2 -
Installation
135 -
Modes et règles
1 -
Online and Mobile Apps
66 -
Service and Storage
71 -
SmartThings
4 -
Troubleshooting
661