Arlo|Smart Home Security|Wireless HD Security Cameras

Reply
Discussion stats
  • 2 Replies
  • 222 Views
  • 0 Likes
  • 2 In Conversation
MFaucher
Aspirant
Aspirant

I have been unable to add by VMC2032 as a device in my Arlo App.  I do have two other cameras in there.  It has been in there before but I took it down to power it and inadvertently removed it as a device on my App.  So I went through the synchronization process but after the chime the camera would slow blink for about 5-6 seconds then stop.  It would not connect.  Went through all the trouble shooting steps and couldn't figure out what was wrong so thought I'd try a power cycle and reset.  I held the button for 30 seconds (timed it) and it went through various LED flashes, blue and amber, but then went right back to the slow blue blink and won't stop.  It's been blinking for some time.

2 REPLIES 2
StephenB
Guru Guru
Guru

@MFaucher wrote:

 I held the button for 30 seconds (timed it) and it went through various LED flashes, blue and amber, but then went right back to the slow blue blink and won't stop.  It's been blinking for some time.


That is expected.  Did you try to add back the camera after the reset?

MFaucher
Aspirant
Aspirant

Just tried to add again and it worked.  Thank you.