Contacts repeatedly corrode
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I’m a seasoned veteran with Arlo. I just built a house at the shore and ordered and set up multiple cameras and solar panels. I’ve had a recurrent and persistent problem with the contact points corroding, both outside and inside the housing. I’ve had to have housing replaced as well as a solar panel. Arlo has been fairly good about doing it as these items are essentially brand new but I’ve tried everything including battery terminal protector but the still corrode and discharge. I climb the ladder take them down clean them in and out and put back, but I can’t keep doing that. Ideas?? Arlo? I think you have a design issue.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I heard that Dielectric grease at the contact seam to prevent water entry... it doesn't need alot
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It helps but I continue to have problems intermittently.
-
5s
1 -
Accessing Local Storage
2 -
Accessing Local Storage.
1 -
Activity Zones
1 -
Arlo Cameras
1 -
arlo not working
1 -
Arlo Pro 2
1 -
Arlo Pro 5
7 -
Arlo Pro 5S 2K
2 -
Arlo Secure
1 -
Arlo solar panel
1 -
ArloPro5
1 -
audio
2 -
Automation
1 -
Before You Buy
2 -
Cable Length
1 -
Charging
1 -
charging unit
1 -
Clicking sound
1 -
cloud storage retention
1 -
Costa Rica
1 -
drained battery
2 -
Firmware
1 -
internationl usage-abroad help
1 -
low power mode
1 -
Magenta screen
1 -
metal barns
1 -
Motion Detection
2 -
Night vision
1 -
No recordings
1 -
No Recordings with Activity Zones
1 -
Pro 5s
2 -
Risoluzione dei problemi
1 -
Routine
1 -
Table Top Mount
1 -
Troubleshooting
2 -
Wifi connection
1 -
wind
1 -
Zones
1
- « Previous
- Next »