How to quickly switch off motion detection?

[Manskow]

We use the cameras at our cabin. When we arrive, and when staying, i want to switch off the motion detection. But when selecting "No motion detection", it still records and alerts when we move pass the cameras. I also tried to set the scheduler to "All motion off" in periods, still not working. I had to remove the batteries when staying at the cabin.... How can I easilly switch off detection?

[Showguy]

One of the default modes is " all motion off" chose that mode and nothing will record. If for some reason you deleted that mode you can easily recreate it by adding a mode and make sure motion is off (grey) when creating the mode.

[TomMac]

As showguy mentioned... the running men must be GRAY and no motion record will occur. You can check the color of the running man from the camera live view screen ( top row of camera )

Here's a copy of messg to set up ALL MOTION ON... ALL OFF MOTION is the same method BUT THE CHECK MARKS WILL BE BLACK.

so go into SETTINGS/MODES  click edit (pencil)for the mode all motion off and make sure all are black

‎2015-08-01 01:24 PM

---

soxnd wrote:

I went to modes and couoldn't find all motions on

---

It is ONE of the two defalt modes... MOTION ON ( or similar named ) and MOTION OFF

If you deleted it, you can remake it;

Go to SETTINGS / MODES... go to the top right and click the ADD button

A new window pops up and will show every camera you have... GIVE the MODE a name lile ALL CAMERA MOTION ON ( or similar that you like )

Make sure each 'check mark' at the end of each camera line is GREEN

should look like this;

The GREEN check mark means the camera will be active for motion when the mode is use. ( btw black means not turned on )

[TomMac]

---

soxnd wrote:

I went to modes and couoldn't find all motions on

---

It is ONE of the two defalt modes... MOTION ON ( or similar named ) and MOTION OFF

If you deleted it, you can remake it;

Go to SETTINGS / MODES... go to the top right and click the ADD button

A new window pops up and will show every camera you have... GIVE the MODE a name lile ALL CAMERA MOTION ON ( or similar that you like )

Make sure each 'check mark' at the end of each camera line is GREEN

should look like this;

The GREEN check mark means the camera will be active for motion when the mode is use. ( btw black means not turned on )

[Manskow]

AS mentioned, I aktuelle HAVE set "all motion off", still it records and alerts.....

[TomMac]

---

Manskow wrote:

AS mentioned, I aktuelle HAVE set "all motion off", still it records and alerts.....

---

I know you mentioned it... but did you verify that the mode is correct? 

Most of the problems I see in this area are due to rule and modes... It does take a few times to get them right

If you checked the MODE and its correct, then I can tell you to; (Test after each one)

1) do a reboot of the base first with the power button... it will take about 2-3 mins to fully restart and the cams should re sync automaticly.

2)  delete the MODE  you have for ALL OFF and make a new one.  Sometihings that will clear a glitch.

3) do a factory reset of the base... it will require you to re-sync the cameras after