Arlo|Smart Home Security|Wireless HD Security Cameras
Arlo Community

Selective Motion Detection?

Reply
Discussion stats
  • 1 Reply
  • ‎2017-01-17 08:45 AM
  • 3124 Views
  • 1 Like
  • 2 In Conversation
SteveCinLA
Follower
Follower
‎2017-01-17 08:45 AM

I have four cameras installed, two point to my backyard where my dogs are all day. If I turn motion detection on I get constant messages showing my dogs running around.

 

I would like to see my front door and garage areas that my dogs can't access while I am away during the day. Is it possible to schedule only the two front cameras to turn on during the day, and then run motion detection on all four cameras normally at night?

Labels:
0 Likes
Reply
Message 1 of 2
3,124
1 ACCEPTED SOLUTION

Accepted Solutions
TomMac
Guru Guru
Guru
‎2017-01-17 10:07 AM

yes... you need to make a custom mode and then either set manual or set by schedule

 

read this ; https://community.netgear.com/t5/Arlo-Knowledge-Base/How-do-I-create-a-mode-for-my-Arlo-Wire-Free-ca...

--------------------------------------
Morse is faster than texting!
--------------------------------------

View solution in original post

Reply
Message 2 of 2
5,446
1 REPLY 1
TomMac
Guru Guru
Guru
‎2017-01-17 10:07 AM

yes... you need to make a custom mode and then either set manual or set by schedule

 

read this ; https://community.netgear.com/t5/Arlo-Knowledge-Base/How-do-I-create-a-mode-for-my-Arlo-Wire-Free-ca...

--------------------------------------
Morse is faster than texting!
--------------------------------------
Reply
Message 2 of 2
5,447
Related Labels
Discussion stats
  • 1 Reply
  • ‎2017-01-17 08:45 AM
  • 3125 Views
  • 1 Like
  • 2 In Conversation

Arlo
Support

Visit our support page for answers from simple setup to security optimization. Search for something specific or select a product or category for helpful articles and videos.

Visit Arlo Support

Arlo App
for Support

For personalized support specific to the Arlo products you own, access Support from within the Arlo iOS or Android App. Simply login to your Arlo App, go to Settings, Support, then select the Arlo product you would like support for.