- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Attempting to connect my Netgear VMB3000 to my Verizon MiFi Jetpack Hotspot that has no ethernet port. There are two socket inputs to the Hotspot: 1) Mini-USB Power, and 2) USB-2 Data. How is everyone connecting or "syncing" the Base and Hotspot with cabling? Both sockets CANNOT be used at the same time due to a sliding blocker!
BTW, since my camera is currently synced to the Base, is there any way I can look at one of the USB connections on the Base and see Camera output just over the my LAN until I get fully WAN through Internet?
- Related Labels:
-
Installation
-
Troubleshooting
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Since you need an Ethernet port so the base can connect, use a WiFi extender that's connected to your hotspot. Connect the base to the extender Ethernet port and all should work fine.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks but the exact problem is how does one CONNECT the WiFi Extender (WN3000RPN3) with Ethernet Socket to the Verizon Jetpack that has USB and mini-USB Power Sockets only?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Via the hotspot's WiFi. An extender connects to the WiFi network that already exists.