Adding additional cameras to existing Arlo system

[freskiw]

i bought your two camara deal  later i bought two more camaras how do i get all four camars displayed

[Schorschi]

You register them just like you did with your first two cameras.

So:

• Press the synch button briefly (on the right edge of the base station). Make sure the third LED from the left is blinking on the base station.
• Briefly press the button on the new camera. Its light should start blinking in blue. When it blinks rapidly (again in blue) and then goes out, the camera is synchronized/registered with the base station. If the camera blinks orange, something is wrong. Open the battery compartment for a few seconds, then try again. (i.e. go back to step 1).
• Discover your new camera as a new device in the UI and configure it to your liking.
• Repeat with your fourth camera.