Arlo|Smart Home Security|Wireless HD Security Cameras
× Arlo End of Life Policy Notice
To view Arlo’s new End of Life Policy, click here.

Reply
Discussion stats
  • 1 Reply
  • 2289 Views
  • 0 Likes
  • 2 In Conversation
jklausen
Aspirant
Aspirant

I have now connected the most used of my 5 cameras to a 220 V power souce. That is fine because it now records some seconds earlier that before (it probably runs in a loop and use the recording if needed). Before i connected the power i had a nice overview in the library - i could see what caused the recording. Now almost all pictures are the same! I have to play each video to se if it is a dog, a car or a person trigging the camera. Is there a way to alter the settings so i can se what caused the recording in the overview?

1 ACCEPTED SOLUTION

Accepted Solutions
TomMac
Guru Guru
Guru

there isn't any setting to change this ( TMK )

 

as to the 3- sec lookback.... it is because on ac , the camera is always recording.  When the trigger event happens, it adds the previous 3 seconds to the front end of the recording ( at the server end )

--------------------------------------
Morse is faster than texting!
--------------------------------------

View solution in original post

1 REPLY 1
TomMac
Guru Guru
Guru

there isn't any setting to change this ( TMK )

 

as to the 3- sec lookback.... it is because on ac , the camera is always recording.  When the trigger event happens, it adds the previous 3 seconds to the front end of the recording ( at the server end )

--------------------------------------
Morse is faster than texting!
--------------------------------------
Discussion stats
  • 1 Reply
  • 2290 Views
  • 0 Likes
  • 2 In Conversation