- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have a new solar panel that was working. I had to disconnect the camera as it was offline. When I reconnected it the battery was charged to 100% and the solar panel connected but I did not see the charging icon on the battery. I thought that maybe it won't show at 100%. The battery is now down to 96% and there isn't any charging icon. Question does the battery need less charge to show the icon or is the panel not connected properly?
Thanks
- Related Labels:
-
Features
-
Troubleshooting
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
No... if the solar panel is connected it should show a "lighting bolt " during daylight hours when panel is producing....
Since it was working before you disconnected, I would go back and verify the plug is properly connected or the connector clean.
Morse is faster than texting!
--------------------------------------
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
New solar panel working great!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
@sagethyme wrote:
New solar panel working great!
Thx for following up!
-
Accessories
1 -
Arlo Go
1 -
Arlo Mobile App
77 -
Arlo Smart
14 -
Before You Buy
181 -
Features
67 -
Firmware Release Notes
6 -
IFTTT (If This Then That)
2 -
Installation
135 -
Modes et règles
1 -
Online and Mobile Apps
66 -
Service and Storage
71 -
SmartThings
4 -
Troubleshooting
661