topic Re: VMB3000 Firmware Update in Arlo

Getting error installing new firmware for VMB3000 so setup stops. Tried resetting and re-powering.

Cliff_J — Wed, 29 Jan 2020 16:31:09 GMT

I have searched everywhere but cannot find the solution. Setting up arlo wirefree hub. Plug in no problems with power. Network connects to router no problem. Open app and hub is found no problem. Set name and timezone no problem. Setup checks for firmware update and gets error installing new firmware, setup is stopped. I’ve reset, repowered and also removed batteries from the camera and each time nothing changed. Can not set up this device!! Any suggestions to update this firmware?

Re: VMB3000 Firmware Update

jguerdat — Wed, 29 Jan 2020 14:23:18 GMT

If the version displayed under the base settings is different from what's listed in the Firmware Release Notes section here, the fastest thing to do is to actually reset (a power cycle is not a reset) by removing all devices from Settings, My Devices and set up fresh again. Make sure the base updates its firmware before doing anything else.

Re: VMB3000 Firmware Update

Cliff_J — Wed, 29 Jan 2020 23:15:55 GMT

Hi, this is a fresh set up. A full reset has been done but I cannot get past the "firmware not up to date on the base station" within the app. Can the base station be connected to a computer to perform the update from netgear?

Re: VMB3000 Firmware Update

jguerdat — Thu, 30 Jan 2020 13:46:00 GMT

No, the base needs to be connected to your network. There's no firmware that can be downloaded and manually pushed to any Arlo device. Sometimes taking the system to another location (friend's house, etc.) has worked at which point returning home has no issues.

Otherwise, use the Contact Support link at the bottom here.

Re: Getting error installing new firmware for VMB3000 so setup stops. Tried resetting and re-powerin

TrumanGregory — Sat, 25 Apr 2020 00:22:36 GMT

Have you found a solution I’m having the same problem?

Re: Getting error installing new firmware for VMB3000 so setup stops. Tried resetting and re-powerin

Cliff_J — Sat, 25 Apr 2020 01:11:49 GMT

Yes, my Arlo was from my brother. He had to log into his account and forget the device. Once that was done everything worked as it should.