topic Re: Confused by scheduling mode in Arlo

Confused by scheduling mode

anuva — Thu, 15 Jun 2017 04:26:36 GMT

I'm trying to set up the cameras to "arm" (record motion and send notification) between 10 PM and 6 AM. I go into Mode -> Schedule -> click the current "All Motion On" block of hours and change Start Time from 6 AM to 10 PM and Stop Time from 9 PM to 6 AM, but I get a purple X icon on both changes and the Save button is greyed out. Thus I can not change the scheduled time. Am I missing something or is this not possible?

Re: Confused by scheduling mode

Streak2 — Thu, 15 Jun 2017 04:50:04 GMT

You need to do it in two steps. Schedule does not allow you to go across days in one step.

So do 10pm to 11:59 and then 12:00 to 6am.

Re: Confused by scheduling mode

anuva — Thu, 15 Jun 2017 05:07:49 GMT

I was afraid that was the case. I'll give that a try. Thanks

Re: Confused by scheduling mode

anuva — Thu, 15 Jun 2017 05:11:49 GMT

Also, what's the difference between "Armed" and "All Motion On" in the Schedule screen?

Re: Confused by scheduling mode

anuva — Thu, 15 Jun 2017 05:38:24 GMT

Nevermind, I figured it out - Armed use to be called All Motion On with the old software/firmware and Netgear didn't delete it automatically during upgrade.

Re: Confused by scheduling mode

TomMac — Thu, 15 Jun 2017 12:09:37 GMT

anuva wrote:

Nevermind, I figured it out - Armed use to be called All Motion On with the old software/firmware and Netgear didn't delete it automatically during upgrade.

If you have ALL MOTION ON along with ARMED, it may be better to remove/delete the "all motion on" mode as some have said it can cause issues at times.

Re: Confused by scheduling mode

anuva — Thu, 15 Jun 2017 16:27:08 GMT

Yup, I did just that. Thanks!