Motion detection on 1% but triggered by slightest movement of leaves

Trojan — Mon, 05 Jun 2017 13:18:30 GMT

I have 3 cameras, the one facing my front garden goes off all the time. I have turned motion detection down to 1% but it still goess off constantly. The only thing I can see moving in the recordings is a few plant leaves blowing in the wind. The other 2 cameras are fine. Any ideas?

Re: Motion detection on 1% but triggered by slightest movement of leaves

TomMac — Mon, 05 Jun 2017 13:24:40 GMT

Yes....

First, reset the camera by opening and closing the battery door. then swap the trouble camera with one working fine.

See if the problem follows the camera ( put sense level back to default of 80% )

If it continues with that camera after above, go to settings and use remove device...then bring the camera back as new ( resets all to default in thebase unit too )

If still NG after, contact NG support

topic Motion detection on 1% but triggered by slightest movement of leaves in Arlo

Motion detection on 1% but triggered by slightest movement of leaves

Re: Motion detection on 1% but triggered by slightest movement of leaves