https://community.arlo.com/t5/Arlo/Live-feed-half-black-and-half-distorted/m-p/1287001#M35235 <P>Open and close the battery door to reset the camera...then test.</P> <P>&nbsp;</P> <P>If it continues, swap location with another camera( if able ) to make sure it's not the location or temp move it ( checks for interference )</P> <P>&nbsp;</P> <P>Last, if continues use REMOVE DEVICE from settings and bring back as if new..this resets all in the base too for that camera....test</P> <P>&nbsp;</P> <P>&nbsp;</P> <P>In the end , keep an eye on it and if it is a repeated issue there is Netgear Support in case of hardware problem</P> Sat, 20 May 2017 11:20:25 GMT TomMac 2017-05-20T11:20:25Z https://community.arlo.com/t5/Arlo/Live-feed-half-black-and-half-distorted/m-p/1286963#M35232 My motion detector went off on and now the live feed shows is half black and the other half is a very distort image. This is on a single interior camera. No changes have been made to the app or where the camer is it just started going this on its own. Sat, 20 May 2017 08:43:21 GMT https://community.arlo.com/t5/Arlo/Live-feed-half-black-and-half-distorted/m-p/1286963#M35232 Saffron 2017-05-20T08:43:21Z https://community.arlo.com/t5/Arlo/Live-feed-half-black-and-half-distorted/m-p/1287001#M35235 <P>Open and close the battery door to reset the camera...then test.</P> <P>&nbsp;</P> <P>If it continues, swap location with another camera( if able ) to make sure it's not the location or temp move it ( checks for interference )</P> <P>&nbsp;</P> <P>Last, if continues use REMOVE DEVICE from settings and bring back as if new..this resets all in the base too for that camera....test</P> <P>&nbsp;</P> <P>&nbsp;</P> <P>In the end , keep an eye on it and if it is a repeated issue there is Netgear Support in case of hardware problem</P> Sat, 20 May 2017 11:20:25 GMT https://community.arlo.com/t5/Arlo/Live-feed-half-black-and-half-distorted/m-p/1287001#M35235 TomMac 2017-05-20T11:20:25Z